Keep cables clear of movable or rotating parts like the power supply and drive cage to prevent them from being cut or crimped when the component is lowered into its normal position. Please try again shortly. Modify your browser’s settings to allow Javascript to execute. A padlock may also be used with a security cable to secure the computer to a fixed object. Javascript is disabled in this browser. The computer comes with a 3-volt lithium coin cell battery.

Uploader: Tajind
Date Added: 13 January 2014
File Size: 54.37 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 96488
Price: Free* [*Free Regsitration Required]

Disconnect the hood sensor from the system board and remove the sensor from the power supply if required Hood Sensor.

Install the expansion card by sliding the card under the slot cover retention latch then pressing the card down into the slot on the system board. Chassis Fan Prepare the computer for disassembly Preparation for Disassembly. Type 3 Battery Holder Pull back on the clip 1 that holds the battery in place, then remove the battery 2.

Remove any memory modules that might interfere with the screwdriver used for removing the speaker. Information and links in this thread may no longer be available or relevant. Lift up on the fan shroud 1rotate the rear of the shroud up 2 pivoting on its top front lip and out of the chassis 3.

The Virtual Agent is currently unavailable. Disconnect the signal 1 and power 2 cables from the drive. May i know the best suitable low profile graphics card for my dc small form factor.


HP Compaq dc7700 Small Form Factor PC – Removing and Replacing the PCI card

Always position the cables to lay properly by themselves. The system will not start if you install unsupported DIMMs.

For more information about recycling programs, go to http: After installing a new processor onto the system board, always update the system ROM to ensure that the latest version of the BIOS is being used on the computer. Squeeze the switch holder retaining clips together at the front of the chassis 1 and push the switch assembly out of the chassis 2.

Graphics card for HP compaq dc – HP Support Community –

This tool applies to Microsoft Windows PC’s only. Intel Pentium 4 Processor 3.

When reinstalling the system board it is important to secure the system board and tray to the chassis with the long retaining screw before performing any subsequent steps. Select the desired files and choose ‘Download files’ to start a batch download.

Compaq DC7700 Small Form Factor

Diskette drive is shown. Remove the drive clutch base Drive Clutch Components.

Technical data is gathered for the products supported by this tool and is used to identify products, provide relevant solutions and automatically update this tool, to improve our products, solutions, services, and your experience as our customer. Battery The battery that comes cmopaq your computer provides power to the real-time clock and has a lifetime of about three years. This page requires Javascript.


Static electricity can damage the electronic components of the computer or optional equipment. Failure to comply with the precautions vorm result in damage to your product or loss of data.

Rotate the top of the speaker back to clear the lip on the top of the chassis, then lift the speaker up and out of the oci 2. Or, view all available drivers for your product below. See your browser’s documentation for specific instructions.

Asia Pacific and Oceania. Message 4 of 4. Release the slot cover retention latch that secures the PCI slot covers by lifting the green tab on the latch and rotating the latch to the full open position 1. Slide the computer cover towards the front of the computer until it stops 2then lift it up and off the chassis. If your problem is solved or question answered by my post, please click the Accepted Solution button in that post.

Intel Celeron D Processor 3. You will need a Torx T screwdriver to remove and re-install the guide screws.

Back to top